Velleman CAMIP12 Quick Installation Guide Bedienungsanleitung PDF herunterladen (Seite 21)

3.6 Trigger

3.6.1 Trigger

You can configure how this camera reacts when there’s an alarm, a motion or a PIR event.

 Detect

Item Description

External Alarm Enable or disable detection from external alarm-in device, and click the title “External Alarm” (in blue) to set “N.O.”

or “N.C.” depending on the configuration of your alarm-in device.

Motion Enable or disable motion detection.

Motion detection is not supported when the stream format is Motion JPEG.

When “Enable” is selected, click “Detection” to enter the motion detection area setting page as follows:

Sensitivity:

Set the detection sensitivity from the drop-down list: High, Normal or Low.

Area Setting:

Set the motion detection area by selecting the area grids with your mouse. Pink grids represent the area that is not being

detected while the transparent grids are the area under detection. You can set multiple areas under detection.

Click “Clear All” to set the whole area undetected.

Click “Select All” to set the whole area under detection.

PIR Enable (ON) or disable (OFF) PIR detection.

Duration Set the duration time for trigger recording (5 / 10 / 20 / 40 seconds).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 68 69

Keine Kommentare

Velleman CAMIP12 Quick Installation Guide Bedienungsanleitung Seite 21