Velleman К8076 Bedienungsanleitung PDF herunterladen (Seite 12)

19. PIC - selection cable

FIG 5.0

Software

FIG 4.0

 Cut off a piece of each wire of the female 'board-to-wire' connector so there is 6cm of wire left on the connector.

See fig. 4.0

 Cut off 5 pieces of shrinkable tube with a lenght equal to 1cm.

 Slide the shrinkable tube over the wires of the female 'board to wire'-connector (fig. 5.0)

 Solder each wire to a metal terminal

 Attention: Always make sure to slide down the shrinking tube far enough from the soldering points!

 Slide the shrinkable tube over the soldered joints and heat them using a hair dryer or, better still, using a paint

stripper.

6cm

1 2 ... 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Velleman К8076 Bedienungsanleitung Seite 12