
CCTVPROM16
V. 02 – 21/08/2013 4 ©Velleman nv
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
• Do not use this product to violate privacy laws or perform other illegal activities.
4. Overview
Refer to the illustrations on page 2 of this manual.
Front panel
LED indications
HDD reading or recording activities on the hard disk
TIMER timed recording is enabled
the DVR is in playing mode
POWER DVR power is on
NAVIGATE
Press one of the four positions on the navigate button to move the cursor up
( ), down ( ), left ( ) or right ( ).
In play-back mode, press the buttons to play/pause (
), stop ( ), fast
rewind (
) or fast forward ( ) the play-back file.
In setting mode, press the up (
) or down ( ) button to change the
setting in the menu.
Press to enter the main menu.
ENTER Press to confirm settings
LIST
List the information of the recorded files.
QUICK SEARCH / RECORD / MOTION / ALARM / TIMER / FULL LIST
Press to play the recorded video.
In playback mode, press to play the recorded file slowly.
In live or playback mode, press to enlarge the image of the selected channel.
SEQ Press to show all screens sequentially in full screen mode. Press again to quit.
4CH: Press to show the 4 channel display mode.
Press a button to select the corresponding channel.
Enter time search mode. Set time range and press START to see all recordings within the time
range.
AUDIO
Press SLOW and ZOOM simultaneous to select live or play-back sounds.
PTZ
(pan tilt zoom)
= SLOW +
Press SLOW and simultaneous to enter or exit PTZ control mode.
USB port
(2x)
Connect a USB flash drive for video backup to one USB port; connect a USB mouse to the
other.
Note: do not connect two USB flash drives or USB mice at the same time.
Rear panel
LAN port Connect the DVR to a local network by plugging a network cable into this port.
connector for video monitor (monitor not included)
4 audio input channels to connect four external audio sources e.g. from cameras with audio.
1 audio output to connect to an audio device, e.g. a speaker (mono).
4 video input channels to connect 4 external video sources e.g. cameras.
VIDEO OUT 1 video output channel to connect the DVR to the main monitor.
use a 9 pin DSUB connector to connect external signals, for example alarm, PTZ…
Kommentare zu diesen Handbüchern