Velleman K8040 Spezifikationen PDF herunterladen (Seite 10)

PIC programmer board

Check the settings of the software

Set the number of the serial port the K8048 is connected to.

Writing the CODE: (standard = ON).

Writing the EEPROM data (standard = ON).

Writing the configuration settings (standard = ON).

ERASE before WRITE: (standard = ON). This indicates that the controller is erased prior to

programming.

LOW VOLTAGE Programming: does not apply to the K8048. All controllers are programmed

with a programming voltage (VPP) of 13 and not 5V.

Select the microcontroller you are using. The included microcontroller belongs to one of the

two following types : PIC16F627 of PIC16F627A. Make sure you have selected the right type

number.

Normally speaking the configuration of the controller is identified with the __CONFIG compiler

directive as early as in the source code. Only experienced users can set these options

manually or adjust them.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Keine Kommentare

Velleman K8040 Spezifikationen Seite 10