Velleman LEDC11 Bedienungsanleitung PDF herunterladen (Seite 4)

LEDC11

V. 01 – 28/03/2013 4 ©Velleman nv

 Make sure short circuit cannot occur between connecting wire

before you turn on the power.

 The supply voltage of the controller ranges between

DC12V~DC24V. Using other voltages will damage the controller.

Step 1 - Open the touch panel

 As shown, gently open the touch panel (for example with a small

screwdriver).

Step 2 – Disconnect the connector cable

 Open the connector and gently remove the connector cable.

Step 3 - Choose a wiring method

Connect the wires according to the mode you will use (see section

Wiring below).

Step 4 - Attach the controller on the wall

Attach and screw the controller to the wall as shown in the picture.

The distance between the screws is 60mm.

1 2 3 4 5 6 7 8 9 ... 43 44

Keine Kommentare

Velleman LEDC11 Bedienungsanleitung Seite 4